How To Quickly Install Fiber Optic Heavy-load Connectors

How to install and use fiber optic cable heavy connector?

Step 1: Remove the end cap from heavy duty cable connectors and thread the cable through it.

Step 2: Use a stripper to peel off approximately 5cm of the cable sheath.

Step 3: Use Miller pliers to cut away the exposed coating near the edge of the clamp, exposing the fiber optic cable.

Step 4: Wipe the exposed fiber optic cable clean with a dust cloth.

Step 5: Cut the fiber optic cable using the clamp.

Step 6: Align the fiber optic cable with the main body slot and insert it. When the fiber optic cable is initially bent, the crimp cap from heavy power connector will be pressed down.

Step 7: Screw back the end cap from heavy duty wire connectors onto the cable and tighten the outer casing from wire connector heavy duty.

The installation of fiber optic heavy duty electric cable connectors is very simple, but it should be noted that fiber optic heavy duty automotive electrical connectors is easily contaminated and damaged, which can lead to a loss of fiber performance. During installation, keep it away from dust and contaminants, and insert it slowly.