How To Use Industrial Connectors
The method of using heavy connector is very simple. We strip the insulation layer of the wire about 10 mm according to the calibrated length, then lift the operating rod, put the wire into heavy duty cable connectors, and release the operating rod. Compared with the method of connecting with electrical tape, connecting the wire with heavy power connector is safer and more reliable, and heavy duty wire connectors is simpler and more convenient to operate. wire connector heavy duty has the advantages of flame retardancy, pressure resistance, insulation, simple operation, firm connection, direct current transmission between wires, strong versatility, and long service life.
When the indoor circuit is renovated, the wires generally run along the wall; however, when we wire the kitchen and bathroom, the circuit is connected to the top of the wall. The ceiling of the bathroom and kitchen cannot be grooved, so everyone will install the wire on the ceiling and cover it with the ceiling. When we groove the circuit, we must be careful not to groove the load-bearing wall. When grooving the wall, the groove should be vertical. If the wall requires a vertical groove, the length of the horizontal groove should not exceed 30cm.
When the heavy duty electric cable connectors circuit is renovated, there must be no joints in the wire pipe. heavy duty automotive electrical connectors If wiring is required, it can be done in the junction box. Strong current and weak current are different and should be routed through the same wire and pipe. They should be wired separately and kept 500mm apart to avoid electromagnetic interference of strong current on weak current. heavy duty 12v connectors In circuit layout, we also need to consider the use of household appliances, appropriate line capacity; and reserve some switches and sockets to avoid insufficient sockets for additional appliances in the future.