If A Push-type Terminal Block Connector Device Has Been Dropped Or Flooded, How Can I Quickly Troubleshoot The Problem?
Publish Time: Author: Site Editor Visit: 26
If the push wire terminal block device has been dropped or soaked in water, you need to disassemble the device and check the solder joints of the push in terminal block wire connector card holder. The appearance of cold solder joints is cracks around the push in wire terminal block solder joints. To re-solder the push fit terminal block connector, you need to use a constant temperature soldering station (about 300℃), and heat each push connector block solder joint for no more than 3 seconds.
