Installation Steps And Details Of The Push-type Connector In The Sd Card Holder
push wire terminal block Mechanical fixation
For occasions where plugging and unplugging are frequent, it is recommended to add mechanical fixation measures around the card holder push in terminal block wire connector. You can add glue to the corresponding position of the card holder push in wire terminal block on the back of the PCB for reinforcement, or use a metal bracket to fix it. Note that the fixing glue cannot affect the insertion and ejection of the SD card.
push fit terminal block connector Antistatic treatment
The operator needs to wear an antistatic wristband before installing push connector block. The metal shell of the card holder should be well connected to the PCB ground wire. If necessary, conductive foam can be added as an auxiliary grounding measure.