What Are The Safe Operating Measures For Cold Press Needle Crimpers?

With the continuous development of science and technology, contact crimper has been widely used. However, due to its working principle and characteristics, if the corresponding safety operation measures are not taken, it may cause casualties and equipment damage. This article will focus on the safety operation measures of d sub contact crimper to ensure the safety of operators and the normal operation of equipment.

1. Preparation before operation

Before operating the manual crimping machine, the operator should first understand the structure, performance and working principle of the equipment, and be familiar with the operating procedures. At the same time, check whether the appearance of the manual crimping machine is intact and whether there are obvious damage or defects. If problems are found, stop using it in time and repair it.

2. Safety measures during operation

During the operation, the operator should wear appropriate labor protection supplies, such as gloves, goggles, etc. At the same time, ensure that the working area is clean and tidy to avoid the presence of debris and dangerous items.

During operation, ensure that the pressure of the manual crimping machine is adjusted appropriately to avoid excessive pressure causing equipment damage or personal injury.

When performing crimping operations, ensure that the quality and specifications of materials such as cables or wires meet the requirements, and avoid using inferior or unqualified materials.

During operation, always pay attention to the temperature and sound changes of the manual crimping machine. If any abnormal situation is found, the machine should be stopped in time for inspection and troubleshooting.

During operation, be careful to avoid the manual crimping machine from tipping over or sliding to avoid casualties and equipment damage.

3. Safety measures after operation

After completing the crimping operation, the manual crimping machine should be restored to its initial state and the power should be turned off. At the same time, the working area should be cleaned to ensure environmental hygiene and cleanliness.

In the case of long-term non-use of the manual crimping machine, regular maintenance and maintenance should be carried out to ensure the good condition of the equipment.

For contact crimping tool with faults, professional personnel should be responsible for repair and replacement of parts, and non-professional personnel should not disassemble and repair it at will.