Wiring Method For Push-in Type Terminal Block Connectors

The wiring steps for push connector block are as follows:

Ensure the power is off: Before making any electrical connections, ensure that the power supply related to the circuit is turned off to avoid the risk of electric shock or circuit malfunction.

Prepare the wires: Using wire strippers or a stripping tool, strip a section of the outer insulation from the wire, usually about 5-10 millimeters, according to the required length. Ensure that the exposed wire ends are clean, undamaged, and not loose.

Insert the wires: Locate the wiring terminals of push wire terminal block.  Typically, each terminal is marked with a + (positive) and - (negative) symbol, indicating the polarity of the connection. Insert the exposed wire ends into the corresponding terminals, ensuring good contact between the wire and the metal spring clip at the bottom of the terminal.

Press to secure: Use your fingers or an appropriate tool to apply moderate pressure to the press button or securing mechanism on top of the terminal. This will secure the wire.

Check the connection: Once the wire is secured, gently pull on the wire to ensure it is firmly connected to the terminal. Also, check the terminal housing to ensure there are no exposed wires or loose parts.