Cleaning Heavy-duty Connectors And Pre-plugging Inspection

Cleaning heavy duty connector 6 pin, including cleaning of contact parts, can be done by wiping with a cloth dampened with anhydrous ethanol and drying before use. Chemical solvents such as toluene that are harmful to heavy duty electrical contacts must not be used.

When heavy duty industrial connector is in a non-interlocked state, it must be covered with the matching dust cover or other dust prevention measures must be taken.

heavy duty male female connector Inspection before insertion

heavy duty multi pin connectors The model, serial number, insertion position, and orientation should conform to the design and process document requirements.

The cable must not be bent, and the sheath must not be damaged;

heavy connector The outer casing and interface should be free from deformation, cracks, thread damage, loose or defective fasteners, and coating peeling;

Locking devices and sealing rings should be intact;

heavy duty cable connectors Sockets, receptacles, and other interfaces must be free from foreign objects or liquids;

Pin plugs and receptacles should not have defects such as skewness or deformation;

The surface of the insulation material at the base of the pin plug should not have cracks or broken metal;

Pin plugs and connectors should not have obvious shrinkage or protrusion. Compared to a normal pin plug on the same plane, its retraction or significant distance should generally not exceed 0.5mm; otherwise, it is necessary to check whether the pin plug or socket is not installed properly or retracted.