How To Fix The Loose Connector Of The Tablet Push-type Terminal Block?

The looseness of the tablet card holder push wire terminal block will affect the stability of data transmission and charging. To solve this problem, the following reinforcement methods can be adopted:

First, confirm the degree of looseness. Slight shaking is within the normal range. If it is obviously loose, it needs to be handled. Prepare tools including precision screwdrivers, tweezers, conductive glue or special electronic glue, dust-free cloth and alcohol cotton pads.

Disassemble the machine after power off. Use a suction cup or pry bar to carefully open the back cover and find the position of the card holder push in terminal block wire connector. Use alcohol cotton pads to clean the contact points and remove the oxide layer and dust. Check whether the push in wire terminal block metal pins are deformed. You can use tweezers to gently adjust them to restore the original shape.

For the snap-on push fit terminal block connector, check whether the plastic snap is broken. If it is intact, you can apply a small amount of conductive glue to the base to enhance the fixation, and be careful to avoid the circuit contacts. If the welded push connector block is loose, it needs to be re-soldered and reinforced. It is recommended to find a professional to operate.

Make sure the connector is fully inserted in place during installation, and a "click" sound indicates locking. Do not install the back cover during testing, and fully assemble after confirming that the function is normal. Avoid frequent plugging and unplugging in daily use, and choose a good quality data cable to reduce interface wear.

If self-treatment is ineffective, it is recommended to send it for repair and replace the entire connector module. Note that the structures of different models vary greatly. It is best to consult the disassembly guide of the specific model before operation. The whole process requires patience and meticulousness to avoid damaging other components.