Two Ways To Generate Copper Terminal Strips

The circuit board diagram is automatically generated based on the content (copper terminal block and cables) in the schematic diagram. If it is changed in the circuit board editor, it is necessary to refresh the circuit board graphics. The display graphics of the circuit board are determined by the parameters in the circuit board configuration, and each circuit board can correspond to a different configuration parameter file.
There are two ways to generate copper distribution block:
When drawing a schematic diagram, insert a copper terminal strip symbol and select the type;
First create a new terminal board, and then associate the device when drawing the schematic diagram; New terminal strip
Select Draw Terminal Strip in "Processing" to open the Terminal Strip List Generation Manager.
Select "New" to modify the new properties of the terminal strip.
Click Edit to enter the Edit Manager and click Insert Single or Multiple Terminals;
If a jumper is required, you can select, select the link point on the terminal where the jumper is required, and insert the jumper;
If multi-layer terminals are required, you can select the corresponding terminal, click Define Layer, and specify the number of terminal layers;