What Are The Daily Maintenance Points For Drone Sd Card Holder Push-type Terminal Connectors?

The daily maintenance points of the drone SD card holder push wire terminal block are as follows:

1. Regular cleaning: Use a soft brush or compressed air to remove dust and debris push in terminal block wire connector in the SD card holder to avoid poor contact caused by accumulation of foreign matter. Pay attention to strength when cleaning and do not damage the metal contacts.
2. Check the contact status: Check push in wire terminal block the metal contacts for oxidation or stains every month. If oxidation is found, you can gently wipe the contacts with an eraser. If it is severely oxidized, use a special electronic contact cleaner.

3. Correct plugging and unplugging operation: When inserting the SD card, ensure the correct direction and avoid forced insertion. When removing it, press the ejection mechanism first, and wait for the SD card to be partially ejected before removing it. Do not pull it hard directly.

4. Dust protection: When the drone is not in use, it is recommended to cover the SD card holder push fit terminal block connector with a dust cover. If there is no special dust cover, you can temporarily seal the card slot with tape.

5. push connector block Environmental protection: Avoid using it in humid, dusty or extreme temperature environments. High humidity environment can easily lead to oxidation of contacts, and dust will accelerate wear.

6. Regular inspection: Check whether the fixing screws of the SD card holder are loose every 3 months, and whether the card holder is firmly connected to the motherboard. If looseness is found, tighten it in time.

7. Use reliable quality SD cards: Poor quality SD cards may wear the card holder due to large dimensional tolerances. It is recommended to use standard specification memory cards of well-known brands.

8. Avoid frequent plugging and unplugging: Try to reduce unnecessary plugging and unplugging operations, check the required materials before each flight, and avoid repeatedly replacing the SD card during flight.

9. Transportation protection: The SD card should be removed when transporting the drone to prevent vibration from damaging the card holder or the SD card from breaking and getting stuck in the slot.

10. Abnormal handling: If problems such as difficulty in plugging and unplugging the card and unstable reading are found, stop using it immediately and send it for repair to avoid forced operation to expand the fault.

The above maintenance measures can effectively extend the service life of the SD card holder and ensure stable data transmission. The power should be turned off during maintenance to avoid the risk of short circuit.